rebooting... Cobalt Microserver Diagnostics - 'We serve it, you surf it' Built Tue May 25 15:58:41 PDT 1999 1.LCD Test................................PASS 2.Controller Test.........................PASS 5.Bank 0:.................................64M 6.Bank 1:.................................0M 7.Bank 2:.................................64M 8.Bank 3:.................................0M 9.Serial Test.............................PASS 10.PCI Expansion Slot....................**EMPTY** 12.IDE Test................................PASS 13.Ethernet Test...........................PASS 16.RTC Test................................PASS BOOTLOADER ramcode: selected partition /dev/hda1 Decompressing done Executing bootloader kernel... Decompressing - done. >> NetBSD/cobalt 3.99.15 Bootloader, Revision 0.1 [@0x80f00000] >> (rthille@, Fri May 5 07:12:47 PDT 2006) >> Memory: 131072 k >> PROM boot string: root=/dev/hda1 ro Boot [wd0a:netbsd]: Loading: wd0a:netbsd 2554720+148584 [82592+73799]=0x2ba67c Starting at 0x80001000 Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006 The NetBSD Foundation, Inc. All rights reserved. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 3.99.17 (GENERIC) #1: Sun Mar 26 14:15:33 PST 2006 rthille@iceqube.thille.org:/home/system/NetBSD/current/obj/sys/arch/cobalt/compile/GENERIC total memory = 128 MB avail memory = 122 MB mainbus0 (root) com0 at mainbus0 addr 0x1c800000 level 3: st16650a, working fifo com0: console cpu0 at mainbus0: QED RM5200 CPU (0x28a0) Rev. 10.0 with built-in FPU Rev. 10.0 cpu0: 32KB/32B 2-way set-associative L1 Instruction cache, 48 TLB entries cpu0: 32KB/32B 2-way set-associative write-back L1 Data cache panel0 at mainbus0 addr 0x1f000000 gt0 at mainbus0 addr 0x14000000 pci0 at gt0 pci0: i/o space, memory space enabled, rd/line, wr/inv ok pchb0 at pci0 dev 0 function 0: Galileo GT-64111 System Controller, rev 1 tlp0 at pci0 dev 7 function 0: DECchip 21143 Ethernet, pass 4.1 tlp0: interrupting at level 1 tlp0: Ethernet address 00:10:e0:00:a7:56 lxtphy0 at tlp0 phy 1: LXT970 10/100 media interface, rev. 3 lxtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto siop0 at pci0 dev 8 function 0: Symbios Logic 53c860 (ultra scsi) siop0: interrupting at irq 4 scsibus0 at siop0: 8 targets, 8 luns per target pcib0 at pci0 dev 9 function 0 pcib0: VIA Technologies VT82C586 PCI-ISA Bridge, rev 39 viaide0 at pci0 dev 9 function 1 viaide0: VIA Technologies VT82C586 (Apollo VP) ATA33 controller viaide0: bus-master DMA support present viaide0: primary channel configured to compatibility mode viaide0: primary channel interrupting at irq 14 atabus0 at viaide0 channel 0 viaide0: secondary channel configured to compatibility mode viaide0: secondary channel interrupting at irq 15 atabus1 at viaide0 channel 1 VIA Technologies VT83C572 USB Controller (USB serial bus, revision 0x02) at pci0 dev 9 function 2 not configured tlp1 at pci0 dev 12 function 0: DECchip 21143 Ethernet, pass 4.1 tlp1: interrupting at level 2 tlp1: Ethernet address 00:10:e0:00:a8:6f lxtphy1 at tlp1 phy 1: LXT970 10/100 media interface, rev. 3 lxtphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto Kernelized RAIDframe activated scsibus0: waiting 2 seconds for devices to settle... wd0 at atabus0 drive 0: wd0: drive supports 16-sector PIO transfers, LBA48 addressing wd0: 189 GB, 395136 cyl, 16 head, 63 sec, 512 bytes/sect x 398297088 sectors wd0: 32-bit data port wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133) wd1 at atabus0 drive 1: wd1: drive supports 16-sector PIO transfers, LBA48 addressing wd1: 189 GB, 395136 cyl, 16 head, 63 sec, 512 bytes/sect x 398297088 sectors wd1: 32-bit data port wd1: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133) wd0(viaide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (Ultra/33) (using DMA) wd1(viaide0:0:1): using PIO mode 4, Ultra-DMA mode 2 (Ultra/33) (using DMA) raid0: RAID Level 1 raid0: Components: /dev/wd0a /dev/wd1a raid0: Total Sectors: 398034816 (194352 MB) boot device: raid0 root on raid0a dumps on raid0b root file system type: ffs Fri May 5 19:53:48 GMT 2006 swapctl: adding /dev/raid0b as swap device at priority 0 swapctl: adding /dev/wd0b as swap device at priority 0 Checking for botched superblock upgrades: done. Starting file system checks: /dev/rwd1e: file system is clean; not checking /dev/rraid0a: file system is clean; not checking /dev/rraid0e: file system is clean; not checking /dev/rraid0f: file system is clean; not checking /dev/rraid0g: file system is clean; not checking /dev/rraid0h: file system is clean; not checking /dev/rraid0i: file system is clean; not checking /dev/rraid0j: file system is clean; not checking /dev/rraid0k: file system is clean; not checking /dev/rraid0l: file system is clean; not checking Setting tty flags. Setting sysctl variables: net.inet.ip.forwarding: 0 -> 1 net.inet.ip.allowsrcrt: 1 -> 0 net.inet.ip.redirect: 1 -> 0 net.inet.ip.directed-broadcast: 0 -> 0 Starting network. Hostname: iceqube.thille.org Configuring network interfaces: tlp0tlp0: link state changed to DOWN . add net default: gateway 10.0.1.2 Adding interface aliases: Building databases... Starting syslogd. Mounting all filesystems... May 5 12:53:57 iceqube /netbsd: tlp0: link state changed to DOWN May 5 12:53:58 iceqube /netbsd: tlp0: link state changed to UP Starting svscan. Checking for core dump... savecore: no core dump Clearing /tmp. Checking quotas: done. Setting securelevel: kern.securelevel: 0 -> 1 Starting virecover. Starting local daemons:. Updating motd. Starting ntpd. Starting sshd. /dev/rraid0d: Parity status: clean Starting inetd. Starting cron. Fri May 5 12:54:07 PDT 2006 NetBSD/cobalt (iceqube.thille.org) (tty00) login: